Replacing The Replacing The Pw Heat Pipe Fans (H-Pipe Top And H-Pipe Bot) - Christie CP2208-LP Service Manual

a) Remove the four screws on the top of the bracket.
b) Remove the rear radiator filter.
c) Remove the two screws on the front of the bracket.
d) Remove the two screws on the bottom of the bracket.
e) Raise the bracket off the alignment pins
f) Release the coolant hose from the radiator fan support bracket.
You may need to loosen the nut securing the coolant hose in place.
Disconnect the coolant hose using the quick disconnect.
g) Remove the radiator fan support bracket with fan assemblies from the projector.
6. Remove the defective fan from the mounting plate (pull off through rubber standoffs).
7. Release the defective fan from the inline connector and remove it.
8. To replace the fan, complete these steps in reverse order.
Replacing the Replacing the PW heat pipe fans
(H-PIPE TOP and H-PIPE BOT)
The PW heat pipe fans are located behind the rear skin and provide cooling for the light module.
Estimated replacement time: 19 minutes
1. Remove the top skin (on page 32).
2. Remove the rear skin (on page 37).
3. Remove the two screws securing the fan bracket.
4. Disconnect the inline connectors for both fans.
CP2208-LP Service Manual
020-102263-01 Rev. 1 (09-2016)
Copyright 2016 Christie Digital Systems USA Inc. All rights reserved.
©
Ventilation and cooling
53