Christie CP2420-Xe Service Manual page 81

6. Remove the four screws securing the igniter to the baseplate.
Look through the exhaust duct to get a better view of the igniter's rear screws.
7. Pull up the igniter cover towards the anode yoke to gain access to the igniter.
8. Remove two bolts to disconnect the LPS +, anode + and igniter - wires from the igniter.
9. Disconnect the anode braid from the igniter.
10. To re-install, follow these steps in reverse order.
Check all connections carefully.
CP2420-Xe and CP4420-Xe Service Guide
020-103566-02 Rev. 1 (07-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Lamp compartment
81