Lamp Compartment; Lamp - Christie CP2420-Xe Service Manual

Lamp compartment

Learn how to replace the components in the lamp compartment.

Lamp

Learn how to replace the lamp.
Warning! If not avoided, the following could result in death or serious injury.
• This procedure must be performed by Christie qualified technicians.
• SHOCK HAZARD! Disconnect the product from AC before installing, moving, servicing, cleaning,
removing components, or opening any enclosure.
• EXPLOSION HAZARD! Allow sufficient time for the lamp to cool down before powering down the
product, disconnecting it from AC, and opening the lamp door.
• EXPLOSION HAZARD! Handle a lamp by the cathode and anode end shafts only. Do not handle
the lamp by the glass.
• EXPLOSION HAZARD! Do not over-tighten the lamp.
• EXPLOSION HAZARD! Always wear manufacturer approved protective safety clothing (gloves,
jacket, face shield) whenever the lamp door is open or when handling the lamp. Any local or
federal specifications take precedence over Christie's protective clothing recommendations.
1. Wearing authorized protective safety gear, unlock and open the lamp door.
If required, release the latch mechanism to remove the door entirely.
2. Remove the lamp.
a) Remove the front lamp duct to reveal the cathode end (-) of the lamp.
CP2420-Xe and CP4420-Xe Service Guide
020-103566-02 Rev. 1 (07-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
74