Fold Mirror - Christie CP2420-Xe Service Manual

Make sure to place the cold mirror into the holder with its reflective surface facing in. The
reflective side shows no gap with its reflection when an object is held at the surface. The non-
reflective side shows a prominent gap.
Reflective side—No gap between reflection
7. After installation, perform LampLOC
(MCGD) calibration.

Fold mirror

The fold mirror is located under the front section of the projector.
1. Remove the four screws securing the fold mirror cover plate under the front portion of the
projector.
2. Remove one screw from each of the three tabs.
CP2420-Xe and CP4420-Xe Service Guide
020-103566-02 Rev. 1 (07-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Non-reflective side—Gap between reflection
™
alignment (on page 21) and Measured Color Gamut Data
Optics
102