Activating Marriage - Christie CP2420-Xe Service Manual

11. Repeat steps 7 to 10 for the remaining corners.
12. If necessary, reset the correction back to zero (no correction) or the previously saved
correction by selecting Reset.
In the Reset dialog, reset the current corner or all four corners. When the locations and value
are set, select Reset.
13. To save the current ECC settings, when the convergence is complete, select Save beside the
ILS file named at the top of the panel.

Activating marriage

After selecting the IMB type, you must install the IMB and complete marriage to display secure
content and to comply with the Digital Cinema Initiatives (DCI) specification. You cannot complete
marriage remotely.
For more information on marriage, refer to CineLife+ User Guide (P/N: 020-103073-XX).
You cannot complete marriage remotely because you must be able to press the Marriage button on
the input panel during the marriage process.
1. In the left navigation menu, select Service Setup > Marriage Setup.
2. Select Start and complete the Marriage Setup wizard.
3. Select Finish.
4. Verify the marriage ring is installed correctly and an anti-tamper alarm does not appear on the
touch panel.
CP2420-Xe and CP4420-Xe Service Guide
020-103566-02 Rev. 1 (07-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Service setups
28