Uv Filter - Christie CP2420-Xe Service Manual

9. Remove four pressure clips to remove the front and rear reflectors.
10. To re-install, follow these steps in reverse order.
11. Perform LampLOC

UV filter

The UV filter is located at the front of the lamp compartment.
Warning! If not avoided, the following could result in death or serious injury.
• This procedure must be performed by Christie qualified technicians.
• SHOCK HAZARD! Disconnect the product from AC before installing, moving, servicing, cleaning,
removing components, or opening any enclosure.
• EXPLOSION HAZARD! Always wear manufacturer approved protective safety clothing (gloves,
jacket, face shield) whenever the lamp door is open or when handling the lamp. Any local or
federal specifications take precedence over Christie's protective clothing recommendations.
• Always wear clean, powder-free latex gloves when handling optical components.
1. Remove the lamp door (on page 53).
2. For safety reasons, remove the lamp (on page 74).
3. Remove a screw from each of the tabs securing the filter.
CP2420-Xe and CP4420-Xe Service Guide
020-103566-02 Rev. 1 (07-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
™
alignment (on page 21).
Lamp compartment
86