2. Lift up the cover just enough for the bottom tabs to clear the frame and remove.
3. To re-install, follow these steps in reverse order.
When installing the cover, insert the tabbed end first then lift the cover until top tab clips into
place.
Access panel frame
The access panel frame is located on the right side near the front of the projector and provides access
to the components in the card cage and light engine compartments.
1. Remove the communications panel cover (on page 54).
2. Remove the light engine air filter cover (on page 54) (including filter).
3. Remove the four screws from the top of the access panel frame securing it to the chassis.
4. Tilt the access panel frame a little to the front (lift the left side) to clear the low voltage power
supply/lamp power supply (LVPS/LPS) cover and remove.
5. To re-install, follow these steps in reverse order.
Rear top cover
Learn how to remove the rear top cover.
1. Remove the external ducting.
CP2420-Xe and CP4420-Xe Service Guide
020-103566-02 Rev. 1 (07-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Projector covers and feet
55