Christie CP2420-Xe Service Manual page 75

b) Loosen set screws from negative/cathode and positive/ anode lamp connectors.
Make sure to apply minimal torque and do not stress the quartz tube.
c) Carefully slip the positive anode connector off the front of the lamp.
d) Handling by the cathode end only, unscrew the lamp from the cathode connector.
e) Carefully remove the lamp from the projector and immediately place it inside the
protective cover or original packaging.
f) Place the lamp on the floor where it cannot fall or be bumped.
Handle box with extreme caution; the lamp is hazardous even when packaged. Dispose of
the lamp box according to safety regulations for your area.
3. Install the new lamp.
a) Remove the protective cover from the new lamp by removing the tape, knurled nut and
locking star washer securing it to its cover.
CP2420-Xe and CP4420-Xe Service Guide
020-103566-02 Rev. 1 (07-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Lamp compartment
75