ADJUSTMENT OF PRINTING RESULTS
Fine Adjustment of Print Position and Cut Length
Depending on your print media and the environment, the print
position may be shifted or cut length may be different from the
setting. If you cannot get the result you expected even after
setting the cut length and margins, fine-tune the print position and
cut length.
For this product, the following adjustments can be set for for
each type and size of print media.
FUNCTION
Horizontal adjust
Vertical adjust
Length adjust
IMPORTANT
•
If the situation is not improved by adjusting the adjustment
function, clean the transport roller. (P.184) Also, make sure
that there is no dirt on the print media.
Fine Adjustment of the Print Start
Position (Horizontal Adjust)
[Example] When printing on a tube in the "Centered" position,
the text is shifted to the left, so move the print start position
2.0 mm to the right.
Move the print start position
2.0 mm to the right.
1
Press
the [Adjust] key.
58
DETAILS
Fine-tune the print start position.
Fine-tune the print position
in the vertical direction.
Fine-tune the cut length.
ABCD
ABCD
2
Use [
] or [
], to select "Horizontal adjust"
and press the [Enter] key.
Adjustments
Horiz. adjust
Vertical adjust
L e n g t h a dj u s t
3
Use [
] or [
] to select "PO, "
and press the [Enter] key.
Horizontal adjust
PHZF
PP+
PROMARK-PL
4
Use [ ] to display "R 2.0mm"
and then press the [Enter] key.
H o r izon t al adj us t
A
Left 0. 7
5
Press
[Shift] + [Canc] key.
•
The display returns to the character input display.
IMPORTANT
•
Horizontal adjust is not available for PP+.
L 1.0mm
L
0,7mm
Normal