Table of Contents
Advertisement
Replacing the Print Media
5
(When using a tube or plate)
Pull out the tube (or plate).
•
If the tube (or plate) cannot be removed, close the cover and
press the [Remove] key again.
6
Remove the attachment
(or cassette).
•
While pulling the lever to the right, lift it upward to remove it.
2
1
NOTE
•
Keep the label cassette with the slack of the tape removed.
7
Load
the print media. (P.20)
IMPORTANT
•
When the print media feed is reversed, the ribbon in the
ribbon cassette may become slack. If the ribbon is slack,
remove the ribbon cassette and remove the slack in the
ribbon. (P.18)
•
For soft tubes, using the [Remove] key to feed backwards
may damage the tube. In such cases, follow the procedure
described in "For Thin Tubes (P.23)" to remove the tube.
24
Using the (Optional) Tube Warmer
The tube warmer is an attachment that warms up tubes that
have become stiff at low temperatures to make them easier to
print on and feed into the printer.
CAUTION
•
Do not leave the tube warmer heated with a tube set in it.
Excessive heating of a tube may cause a fire.
•
Do not put your fingers in the tube warmer's tube insertion
and tube delivery ports. Doing so may result in burns.
Set the Tube in the Tube Warmer
IMPORTANT
•
The tube warmer can be used with the following tube types
and sizes. This device cannot print correctly on other types
of tubes.
Type: Tube, clear tube
Size: Φ1.5 to Φ6.5 mm internal diameter
•
If the tube gets too warm, the device may not print on it
correctly. Print as soon as possible after loading the tube.
•
Do not use the following types of tubes. Not only will the
product not print cleanly, but use with such tubes may also
cause a malfunction.
Broken / Crushed / Twisted / Uneven thickness / Soiled /
Uneven / Wet
•
It is not possible to print on dirty tubes or plates. Wipe off
any dirt or dust with a dry cloth. Also, do not use tubes or
plates that have oil or other stains that cannot be wiped off.
•
If the tube warmer cleaner is dirty, it may cause blurred
printing. Clean or replace it periodically. For more
information, refer to "Cleaning/Replacing the Cleaners (P.89)" .
NOTE
•
For information on how to remove a tube that has been set
into the printer, and on how to remove the tube warmer,
refer to "Replacing the Print Media (P.23)" .
Advertisement
Table of Contents
