Table of Contents
Advertisement
LOADING THE PRINT MEDIA
Loading a Tube or Plate
IMPORTANT
•
Do not use the following types of tubes. Not only will the
product not print cleanly, but use with such tubes may also
cause a malfunction.
Broken / Crushed / Twisted / Uneven thickness / Soiled /
Uneven / Wet
•
You cannot print on dirty tubes or plates. Wipe off any dirt
or dust with a dry cloth. Also, do not use tubes or plates
that have oil or other stains that cannot be wiped off.
NOTE
•
Please purchase commercially available tubes and plates
for use. For more information on the sizes that can be used,
refer to "Height limit table for each media and font size" (P.116)" .
•
The procedure for removing set print media from the printer,
please refer to "Replacing the Print Media (P.23)" .
•
Periodically clean or replace the cleaner of attachment. Dirt
on the cleaner will cause print smears. For details, refer to
"Cleaning/Replacing the Cleaners (P.89)" .
1
Prepare
the attachment.
•
For tubes (round).
Use the cleaner (blue) by attaching it to the tube attachment.
•
For flat tubes
Use the cleaner (blue) by attaching it to the (optional) plate
and flat tube attachment.
T2000-TA / T2000-PA
20
•
For plates
Use the plate cleaner (gray) by attaching it to the (optional)
plate and flat tube attachment.
2
Open
the cover.
3
Install the tube attachment
into the printer.
Align the attachment with the slot on the printer and push it
in firmly until it clicks into place.
1
2
4
Set the size switch lever to match the size
of the tube (or the plate size).
For plates, set it to "Φ2.6mm~Φ10.0mm. "
Advertisement
Table of Contents
