Table of Contents
Advertisement
Fine Adjustment of Print Position and Cut Length
Fine-tuning the Print Position in the
Vertical Direction (Vertical Adjust)
[Example] When printing on a tube ( Φ 6.0 mm), the print
position is shifted upward, so move the print position
downward by 0.5 mm.
ABCD
ABCD
1
Press
the [Adjust] key.
2
Use [
] or [
], to select "VerticalPosition, " and
press the [Enter] key.
Adjustments
Horiz. adjust
Vertical adjust
Le n g t h a d j u st
3
Use [
] or [
] to select "PO, "
and press the [Enter] key.
Horizontal adjust
PO
POZ
PHM CLEAR
4
Use [
] or [
] to select "PO-05, "
and press the [Enter] key.
P O si z e :
PO-04
Normal
PO-05
Normal
PO-06
Normal
Move the print position
downward by 0.5 mm.
5
Use [
] to display "Down 0.5 mm" and press
the [Enter] key.
Vertical adjust
[ Down 0. 5㎜]
•
Use [
] (upward)/[
] (downward) to enter the adjust
value.
•
You can adjust the range from 1.0 mm upward to 1.0 mm
downward in 0.1 mm increments.
6
Press
[Shift] + [Canc] key.
•
The display returns to the character input display.
59
59
Advertisement
Table of Contents
