Table of Contents
Advertisement
List of Message
If a problem occurs while connected to the printer, an error message or warning message will be displayed on the status monitor. Read
the message, and follow the corresponding procedure.
MESSAGE
Low ribbon level
Low battery level
No Media
End of Media
End of Ribbon
Start of Media Not Detect
No ribbon cassette
Media JAM
Cover is Open
Check of the size
switch lever
Cutter Initialization Error
Head initialization error
Head print position error
Warmer temperature rise
delay error
Warmer abnormal
temperature error
The ribbon is running low. Prepare a new ribbon cassette
For more information, refer to „Battery is low. (P.110)" .
For more information, refer to „Print media isn't set. (P.108)
For more information, refer to „End of media. (P.108)" .
For more information, refer to „End of ribbon. (P.108)" .
For more information, refer to „Start of media not detect. Remove media between print head and cutter.
(P.108)" .
For more information, refer to „Ribbon cassette isn't set. (P.108)" .
For more information, refer to „Feed error (P.109)" .
You cannot print with the cover open. Close the cover and press any key.
For more information, refer to „Size switch lever position isn't correct. Continue? (P.109)" .
Press any key. If the same message appears again, contact your place of purchase.
Turn off the printer and set the warmer again. (P.109) If the same message appears again, contact your
place of purchase.
SOLUTION
79 79
Advertisement
Table of Contents
