Table of Contents
Advertisement
Change the Rewind Movement Settings
When printing is finished, the top of the print media stops at
the cutter position. In this case, the print media is sandwiched
between the transport roller 2 and the transport roller 3, and
depending on the material of the print media, the part of the
print media sandwiched between the transport rollers may
be deformed, causing a "Feed error. " If the "Feed error" occurs
repeatedly, try to set the rewind movement to return the top of
the print media to the print head position after printing. The default
setting of the rewind movement is set to "Off. "
Cutter
position
Print head position
1
Press
the [Settings] key.
2
Use [
] or [
and press the [Enter] key.
S et t in g s
P r i n t adj us t
S et t ing
O t h er s
3
Use [
] or [
and press the [Enter] key.
O th e rs
Replace cutter
Rewind movement
AutoO (adapter)
4
Use [
] or [
and press the [Enter] key.
Rewind movement
O
On
96
] to select "Others"
] to select "Rewind movement, "
] to select "On"
5
Press
[Shift] + [Canc] key.
•
The display returns to the character input display.
IMPORTANT
•
When a plate is printed with the Plate Full cut set to "No"
(default setting), the top of the plate will stop at the cutter
position regardless of the rewind movement setting.
•
For thin or soft tubes, the tube may not feed properly if you
print with the rewind movement set to "On. " In this case, set
the rewind movement back to "Off" (default setting) and print.
•
When printing on PO-068Q or PO-06Q, markers with pre-
punched holes, make sure to turn off the Rewind Movement
Settings. Otherwise, the profile might got jammed.
Advertisement
Table of Contents
