Table of Contents
Advertisement
Specify the Cut Length and Alignment
Margin (5 mm)
Alignment (Left)
Pump Room
Cut length (40 mm)
1
Press
the [Seg Len] key.
2
Use [
] or [
] to select "Cut Length, "
and press the [Enter] key.
Cut Length
Cut Length
Alignment
PP+ Print Area
3
Use [
] or [
] to select "Specify, " enter "40.0"
(Cut Length), and then press the [Enter] key.
•
The value can be set by entering numbers or using arrow
keys ([ ] / [ ]).
•
Cut length can be entered in the range of 8 mm to 150 mm
(4 mm to 150 mm for label/plate only) in 0.1 mm increments.
•
Press the [Enter] key to return to the character input
display.
Cut Length
8.0 to 150.0mm
4
Press
the [Seg Len] key.
5
Use [
] or [
] to select "Alignment"
and press the [Enter] key.
Cut Length
Cut Length
Alignment
PP+ Print Area
40.0mm
6
Use [
] or [
] to select "Left"
and enter "5" (margin).
•
The value can be set by entering numbers or using arrow
keys ([ ] / [ ]).
Alignment
Centered
Left
: 5㎜[2 to 5]
Right : 2㎜[2 to 5]
7
Press
the [Enter] key.
•
The display returns to the character input display. Input the
characters.
•
Cut length and alignment can be checked on the display.
NOTE
•
The cut length and alignment can be set for each page.
•
Depending on the character size, some cut lengths cannot
be specified.
•
If you want to change the cut length of all pages, use "Batch
(Cut Length). " (P.46) In Batch (Cut Length), the "Cut Length, "
"Alignment, " "PP+ Print Area, " and "All Line Centering"
settings are applied to all pages.
•
Approximately 60 mm from the print start position, there
may be a slight difference between the specified cut length
and the print result.
•
Depending on your print media and environment, the cut
length and margins may differ from the settings. If the
results are not as expected even after setting the cut
length and margins, fine-tune the cut length and print
position. For more information on fine adjustment of the cut
length and print position, refer to "Fine Adjustment of Print
Position and Cut Length (P.58)" .
•
When the PP+ Print Area is set to "Expansion, " the "Left"
and "Right" margins cannot be set. (They will be set to "0
mm. " ) (P.42)
•
When the print media is a label or a plate, the cut length is
"less than 8.0 mm;" when the PP+ Print Area is "Normal, "
the alignment is "Centered" and the settings cannot be
changed.
•
When the orientation is set to "Vert/Hor char, " the alignment
cannot be set.
41
41
Advertisement
Table of Contents
