Editing Characters And Lines; Setting The Character Size - Partex PROMARK T-2000 User Manual

EDITING CHARACTERS AND LINES

Setting the Character Size

This is how the character size is set. The character size can be
selected from those below; the default value is "3 mm full-width. "
1.3 mm
full-width
200V
2 mm
200V
half-width
2 mm
200V
full-width
2.6 mm
200V
half-width
2.6 mm
200V
full-width
[Example] Set the character size to "3 mm half-width. "
1
Display the page where you want
to change the character size.
2
Press
the [Char Size] key.
3
Use [ ] or [
to select "3 mm half-width. "
•
An "×" will appear next to character sizes that cannot be
selected.
Character Size
3 ㎜
3 ㎜ 100%
4 ㎜
32
3 mm
200V
half-width
3 mm
200V
full-width
4 mm
200V
half-width
4 mm
200V
full-width
200V
6 mm
half-width
200V 6 mm
full-width
], [ ], [ ] to select
50%
50%
4
Press
the [Enter] key.
•
The display returns to the character input display.
•
The character size setting can be checked on the display.
•
If you select "half-width, " the text will be displayed in half-
width.
■
3mm
NOTE
•
The character size can be set for each page.
•
Even if you select half-width characters, symbols will be
printed in full-width.
•
Some character sizes cannot be selected depending on the
number of lines, the cut length setting, and the size of the
print media.
•
No error message will be displayed even if the print data
extends beyond the width (top and bottom) of the print
media. Refer to the following to set the character size and
frame.
•
For more information concerning maximum printable
character size, refer to "Height limit table for each media
and font size". (P.116)