Table of Contents
Advertisement
PROBLEM
The cutting position is off.
The printed area gets cut.
The tube is cut at an angle.
106
CAUSE / THINGS TO CHECK
Are there any objects around the media
delivery port that prevent the media from
being ejected?
Is there any load on the tube or plate
transport?
Is the tube twisted or warped?
Depending on your print media and
environment, the print position may be
shifted or the length of one tube (or one
label) may be different from the setting.
Are the print density and print speed
appropriate?
You may be able to improve the problem
by changing the print priority.
SOLUTION
Do not place any objects around the media delivery
port. If there is an object blocking the outlet, the tube or
label tape may not be ejected straight and may be cut
in a bent shape.
Place the printer and the print media on the same table
(or at the same vertical position) so that no load is
applied to the transport.
When using a tube reel, lighten the load.
Correct any twists or warps before loading. (P.24)
If the end of the tube is bent due to winding or other
reasons, straighten it out or cut off the bent portion
before loading it into the printer.
Make fine adjustments to the print position and cut
length. (P.62)
If the problem is not corrected by using the length
adjust, set the half cut to „Off" and cut with scissors.
Adjust the print density to be darker. (P.61) Slow down
the print speed. (P.61)
Try setting the print priority to „First Print. " (P.95)
Advertisement
Table of Contents
