Set The Tube In The Tube Warmer - Partex PROMARK T-2000 User Manual

Set the Tube in the Tube Warmer

1
Prepare
the tube warmer.
2
Open
the cover.
3
Set the tube warmer
in place.
•
Insert the connector of the tube warmer into the connector
for the tube warmer on the printer and push down on it
vertically until it clicks into place.
4
Set the size switch lever to match the size of the
tube, and set the tube. (P.23)
•
Set the tube in the same way as when using the tube
attachment
5
Close
the cover.
6
Turn on
the printer. (P.16)
7
Check the control settings
of the tube warmer.
•
The current control settings of the warmer will be shown
on the display.
•
The control settings of the warmer can be switched
between Auto (automatic), WAI or RDY (ON), and OFF (OFF).
These options can be cycled through in that order be
pressing the [Warmer] key. (P.8)
■
IMPORTANT
•
When the tube warmer is not set, the tube warmer control
settings are disabled.
•
If you cannot print correctly even with the tube warmer
(for example, printing is blurred), change the temperature
setting of the tube warmer. (P.26)
NOTE
•
When "PHM CLEAR, " "PP+" or "T2000-PWL33" is selected
for the print media in the print settings, and "ON" is selected,
"OFF" will appear on the display. To change the print media,
press the [Print] key. (P.54)
25 25