Table of Contents
Advertisement
IF A TUBE OR LABEL TAPE BECOMES JAMMED
If the print media gets jammed inside the printer, a "Feed error"
message will be displayed on the display and printing will be
canceled. Follow the procedure below to remove the print media.
Feed error
Print media jammed
in media path.
NOTE
•
If the print media is jammed inside the printer but the
message is not displayed, press and hold the [Canc] key
for 2 seconds or more to stop printing, and then follow the
instructions starting from step 2 to remove the print media.
(In this case, the messages shown in the steps below will
not be displayed.
1
After reading the "Feed error"
message, press any key.
•
Instructions will be displayed on the screen.
O p e n the c o v e r.
2
Open
the cover.
•
When the cover is opened, instructions will be displayed on
the screen.
Remove the ribbon
cassette.
100
3
Remove
the ribbon cassette.
•
If the ribbon is wound around the cassette and cannot be
removed, do not remove it forcibly, and proceed to step 4.
4
After removing the ribbon cassette,
press any key.
•
After pressing a key, instructions will be displayed on the
screen.
While pushing the Jam
recovery lever, remove
the print media in the
printer.
5
(When using tube or plate) As shown in the
figure, pull the tube (or plate) out while pressing
the jam release lever in the direction of the
arrow.
1
•
If the tube (or plate) cannot be pulled out, remove the
attachment while pressing the jam release lever in the
direction of the arrow.
•
If the ribbon cassette has not been removed in the previous
step, remove the ribbon cassette.
2
Advertisement
Table of Contents
