Running the Firmware Update
6
Use [
] or [
and press the [Enter] key
Set ti ng s
Co un t er
D ev ic e I nf o
Firmware update
7
Use [
] or [
and press the [Enter] key
Fir m wa re upd at e
No
Yes
Update rmware by a
host PC.
•
If you select "Yes" , the printer will be on standby state to
receive from the firmware update file.
NOTE
•
If you want to cancel the standby state, turn off the printer.
8
Execute the firmware
update file (.exe) on the computer.
•
After checking the current firmware version and the version
of the updater, click [Send].
•
When the update is complete, the printer will automatically
turn off
112
] to select "Firmware update"
] to select "Firmware update"
IMPORTANT
•
Don't do any of the following while updating the firmware.
- Turn off the power.
- Unplug the USB cable.
- Operate any component of the printer.
- Send data to the printer from an application or a printer
driver.
- Put/allow the computer to sleep (the update may not be
performed properly if the computer goes into sleep mode.)
•
If any of the following occurs, the update may not have been
performed correctly. Please check the firmware version on
your device.
- The update may have been interrupted in the event of a
power outage, etc.
- The "Firmware update complete" dialog box does not
appear at least 20 minutes after starting the update.
9
After confirming that the update is complete,
close the firmware update file screen.
•
This completes the firmware update.