Table of Contents
Advertisement
MESSAGE
Size switch lever position isn't correct.
Continue?
Data check.
Resetting completely
Power turned off when saving file.
Checking saved data.
Power turned off when loading file.
Resetting input data.
Power turned off when deleting file.
Checking saved data.
Feed error
Print media jammed in media path.
No ribbon information. No ribbon amount can't
be displayed.
When selecting expansion of Plate Print Area,
only Plate can be printed.
Turn off/on the power.
As warmer temp.
didn't rise enough, warmer was turned off.
As warmer temp.
couldn't be controlled, warmer was turned
off.
Turn off the power and check the AC adapter.
Firmware update failed.
Try the update again.
Communication error
Reconnect to host device.
The size of the print media set on the printing preference display does not match the
position of the size switch lever. (P.20)
If you select „Yes, " printing will start. To reset the settings, select „No" and follow the
instructions on the screen to set the size switch lever to the correct position. Press any
key to start printing.
An error has occurred in the data and all settings have reverted to the settings at the
time of purchase. All saved files have also been deleted.
Check the saved files. If the data is not saved, re-save it.
The data being entered will be deleted. Re-enter the data.
Check the saved files. If the file has not been deleted, delete it.
The print media jammed during printing. Follow the instructions on the screen to remove
the jammed print media. (P.100)
Information could not be read from the IC chip in the ribbon cassette. Or, a ribbon
cassette that has already been used up has been loaded. Press any key and follow the
instructions on the screen.
Set the Cut Length to „Auto. " (P.62)
When the Plate Print Area is set to „Expansion, " a print media other than plates cannot
be selected.
Turn the power back on. If the same message appears again, contact your place of
purchase.
Turn off the printer, and re-set the tube warmer in place again. (P.25) If the same
message appears again, contact your place of purchase.
Turn off the power, unplug the AC adapter from the power outlet, and then contact your
place of purchase.
Press any key to update again.
Press any key.
Perform PC connect (or Bluetooth) again to send data.
DETAILS / SOLUTION
109
109
Advertisement
Table of Contents
