Table of Contents
Advertisement
Printing
NOTE
•
No error message will be displayed even if the print data
extends beyond the width (top and bottom) of the print
media. It is recommended to refer to the preview to make
sure that no characters are missing before printing.
7
Use [ ] to select "Print" and press the [Enter]
key
•
Printing will be started.
/ Pr e vi e w
P r i nt
S e t s t o p r i n t : 2
PO-05
Range:
A l l
IMPORTANT
•
When printing on PO-068Q or PO-06Q, markers with pre-
punched holes, make sure to turn off the Rewind Movement
Settings. Otherwise, the profile might got jammed. For
details, refer to "Change the Rewind Movement Settings"
(P.96)
8
Removing
the Tube.
•
When printing is finished, the tube will be
automatically cut (Full cut). Also, a cut (half cut) can be
made between the tubes.
IMPORTANT
•
After printing, remove the print media from the printer to
prevent warping or deformation of the print media.
•
Do not place any objects around the outlet of this product. If
there is an object blocking the outlet, the tube or label tape
may not be ejected straight and may be cut in a bent shape.
•
Do not pull the tube or label tape forcibly during printing.
Doing so may result in printing failure or malfunction.
NOTE
•
To cancel printing, press the [Canc] key. The printer will
stop printing and cut the print media, then stop. If you press
and hold the key for two seconds or more, the printer will
stop without cutting.
•
The plate will not be half cut. If you set the number of prints
when printing a plate, a cut line (dotted line) will be printed
for each sheet printed.
•
In the default setting, "Plate Full cut" is set to "No, " so if you
print a plate, it will not be cut after printing. Use scissors to
cut it. For more information about the "Plate Full cut" setting,
refer to "Changing the Plate Full Cut (P.64)" .
•
When setting the tube, refer to "Height limit table for each
media and font size". (P.116)
55
55
Advertisement
Table of Contents
