Lateral Implement Offset Adjustment - TeeJet Technologies MATRIX PRO GS User Manual

Lateral Implement Offset Adjustment

To calculate an implement offset adjustment using adjacent guidelines:
1. Create a straight AB line.
2. With assisted/auto steering engaged, drive pass
implement.
3. Turn around and engage assisted/auto steering on pass
the implement or stop while on the AB guideline next to the flags you placed on pass

4. Measure the difference
5. Divide the measured distance
6. Increase or decrease the offset distance
implement offset direction setting.
Field Application

Overlap on the right of pass

Gap on the left of pass

Overlap on the left of pass

Gap on the right of pass
Figure 6-26: Lateral Implement Offset Distance and Direction
Matrix® Pro 570GS ● Matrix® Pro 840GS
 as if you were operating the implement, and place flags at the outside edges of the

between the flags of pass 
and pass

in half. This difference will be the offset adjustment.
 as needed dependent on where the field application overlap occurs and the current
Offset Direction = Left
or
Increase distance offset value
or
Decrease distance offset value
on the adjacent AB guideline. Place additional flags at the outside edges of

.

.
Current Offset Settings
Offset Direction = Right
Decrease distance offset value
Increase distance offset value
Offset Direction = Right
Offset Distance = 0 m
Increase distance offset value
Change to implement offset direction to
left and increase distance offset value
98-05273-ENUS R6
49