Setting Rotation - Sony MLS-X1 User Manual

To change the position and size of a key
Press the [LOC SIZE] button, turning it on, and adjust
the setting values using the trackball/Z-ring.
To change the rotation and viewpoint position of a
key
Press the [ROT] button, turning it on, and adjust the
setting values using the trackball/Z-ring.
To finely adjust the setting values of parameters
Press the [FINE] button, turning it on.
The adjustment mode switches to fine mode, enabling
fine adjustment of setting values using the trackball/
Z-ring.
To restrict the parameters targeted by the
operation
Press the [X] button, [Y] button, or [Z] button,
turning it on.
This enables operation only for the selected axis
using the trackball/Z-ring.
Transforming an image using trackball/Z-ring
operations
You can transform an image as follows using trackball/
Z-ring operations for each two-dimensional transform.
Button Trackball
Horizontal
direction
ASP Change
PERS aspect ratio in
X-axis
direction
LOC Movement in
SIZE X-axis
direction
ROT Rotation
around Y-axis
Device control block display
In the device control block of the ICP-X7000, the display
shows the following information.
• Reference switcher bank name: M/E1 to M/E5, P/P
• Reference resizer name: KEY1 RSZR to KEY8 RSZR
• Selected parameter name: ASP, LOC SIZE, ROT
PERS, BDR, CROP
• X-axis, Y-axis, and Z-axis settings (four edge settings
for crop)
To adjust the setting values of parameters using
the numeric keypad control block
You can press the [X] button, [Y] button, or [Z] button in
the device control block to display the name and value of
parameters on the display of the numeric keypad control
block and then set the X-axis, Y-axis, and Z-axis
Z-ring
Vertical
direction
Change Simultaneous
aspect ratio in change aspect
Y-axis ratio in X-axis
direction direction and
Y-axis
direction
Movement in Scaling
Y-axis (shrink/
direction magnify)
Rotation Change
around X-axis distance from
viewpoint
position
parameters. Enter a value in the numeric keypad area and
press the [ENTER] button to apply the setting.
Note
You can also enter a difference value from the currently
set value using the [TRIM] button.
For details, see "Entering a difference from a current
value" (page 79).
To change parameters to the closest detent
position
Press the [CTR] button once.
To return two-dimensional transform
parameters to the default values
Press the [CTR] button twice. Or press and hold the
[SHIFT] button and press the [CTR] button.
To return two-dimensional transform
parameters to the initial settings
Press the [CLR WORK BUFR] button once.
The two-dimensional transform parameters return to the
initial status saved data setting values.
To return all resizer parameters to the initial
settings
Press the [CLR WORK BUFR] button twice. Or press
and hold the [SHIFT] button and press the [CLR WORK
BUFR] button.
The resizer parameters return to the initial status saved
data setting values.
To return a switcher bank to the initial settings
Press the [M/E DEF RCALL] button twice.
The selected switcher bank returns to the initial status
saved data setting values.

Setting Rotation

Rotating a key (menu)
1
Open the Home > M/E-1 > Key1 > Resizer/Proc Key
> Resizer Adjust/DME Select menu (11101.41).
2
Set the [Resizer] button to the on state.
3
In the [Rotation] group, select a direction of rotation.
X: Rotation in horizontal direction
Y: Rotation in vertical direction
When the [X] button is selected, set the following
parameters.
139