Table of Contents
Advertisement
Restrictions on resizer effects
Restrictions on the use of effects
Of the resizer effects, using mask, drop shadow, or wide
key border requires two units of hardware for the resizer
function.
These are called "dual resizer effects".
In a dual resizer effect, predetermined combinations, key 1
and key 2, key 3 and key 4, key 5 and key 6, key 7 and key
8 are used.
For example, if either of key 1 and key 2 has resizer set to
On, the other key cannot be used for a dual resizer effect.
The same restriction applies when using a resizer DME
wipe in place of resizer.
Impossibility of simultaneous use within the
same keyer
The following combinations of resizer effects cannot be
simultaneously on.
• Mosaic and edge enhance
• Defocus and wide key border
• Mask and drop shadow
• Mask and wide key border
Setting rotation of the resizer
Notes
Either X or Y direction must be specified for rotation. You
cannot make rotation by combining both directions.
When rotating key 1 of the M/E-1 bank, for example, use
the following procedure.
1
Select M/E-1 >Key1 >Processed Key/Resizer menu,
press [Resizer], turning it on.
2
Press [Rotation], turning it on.
The Rotation menu appears.
3
Press [X] or [Y] in the <Rotation> group to select the
direction of rotation.
4
Turn the knobs to adjust the following parameters.
• When [X] is on
Knob Parameter
Adjustment
1
Rotation X
Rotate key
horizontally
4
Perspective
Change
perspective
• When [Y] is on
Knob Parameter
Adjustment
2
Rotation Y
Rotate key
vertically
Knob Parameter
4
Canceling Virtual Images
If an extreme degree of perspective is set for an image, the
part of the image exceeding the virtual view point is
displayed wrapped around on the monitor screen. You can
press [Wrap Around], turning it on, to make a setting not
to show the virtual images.
Setting values
–99.0000 to
+99.0000
0.0000 to
99.9999
Setting values
–99.0000 to
+99.0000
Adjustment
Perspective
Change
perspective
Setting values
0.0000 to
99.9999
159
Resizer
Advertisement
Table of Contents
