Setting Modifiers - Sony MLS-X1 User Manual

Select a wipe pattern in the same way as for the main
pattern.
Notes
• Rotary wipe patterns cannot be selected.
• Some patterns may not be available for a sub
pattern, depending on the selected main pattern.
For details, see "Relationship between main
pattern and sub pattern" (page 150).
3
Open the Home > M/E-1 > Bus/Transition > Wipe >
Pattern Mix/Edge/Direction menu (11109.33).
4
In the [Pattern Mix] group, select a type of pattern
mix.
Mix: Mix
+ NAM: Positive NAM
– NAM: Negative NAM
Morphing: Morphing
When the [Mix] button, [+ NAM] button, or [– NAM]
button is selected, set the following parameter.
No. Parameter
1 Mix Ratio
When the [Morphing] button is selected, set the
following parameters.
No. Parameter
1 Start
2 End
5
In the [Main/Sub Link] group, configure the modifier
link.
Full: Full link mode
Semi: Semi link mode
To disable modifier link, set both the [Full] button
and [Semi] button to the off state.
Setting a dust mix
You can set a dust mix for a selected wipe pattern.
1
Open the Home > M/E-1 > Bus/Transition > Wipe >
Pattern Mix/Edge/Direction menu (11109.33).
2
Set the [Dust Mix] button to the on state and set the
following parameters.
No. Parameter
1 Mix Ratio
Adjustment
Proportion of sub pattern
relative to main pattern
Adjustment
Point in the transition at which
the main pattern is at 100%
Point in the transition at which
the sub pattern is at 100%
Adjustment
Proportion of diamond dust
wipe pattern
No. Parameter
2 H Size
3 V Size
4 Flash Rate

Setting Modifiers

You can add modifiers to modify a wipe pattern.
Relationship between wipe pattern and
modifiers
Some modifiers may not be available, depending on the
wipe pattern.
The following table shows the supported modifiers for
each wipe pattern.
: Available
a
×: Not available
Modifier Standard
wipes
Direction a
Split a
Edge a
a)
Position a
Rotation a
d)
Aspect a
Multiplication a
f)
Pairing a
Modulation a
(H, V)
g)
Modulation a
(Fringe)
g)
a
Spring
h)
Spiral a
a) Pattern numbers 1 to 16, 19, and 20 are not available.
b) Pattern numbers 300 to 303 are not available.
c) Pattern numbers 100 to 103, 150, 151, 156, 158, 604, and 606 are not
available.
d) Pattern numbers 1 to 8, 17, and 18 are not available.
e) Pattern numbers 220 to 223 are not available.
f) Pattern numbers 19 to 20 are not available.
g) Pattern numbers 1 to 20 and 22 are not available.
h) Pattern numbers 1 to 20, 22, and 24 are not available.
Main pattern and sub pattern modifiers
The following modifiers are common to the main pattern
and sub pattern.
• Direction
• Split
• Edge
151
Adjustment
Particle width
Particle height
Rate of generation of
particles
Enhanced Rotary Mosaic
wipes wipes wipes
a a a
a × a
a a a
b) c)
a a ×
c)
a a ×
a × ×
e)
a a a
a × ×
a a ×
a × ×
a
× ×
a × ×
Random/
diamond
dust
wipes
a
a
a
×
×
×
×
×
×
×
×
×