Setting The Image Effect Function; Executing The Image Effect Function - Sony MLS-X1 User Manual

Setting the Image Effect Function

This section describes the M/E-1 menu as an example.
Assigning a DME channel to a
background bus
Note
Only one DME channel can be used on each background
bus.
1
Open the Home > M/E-1 > Bus/Transition > Bus >
Image Effect menu (11109.12).
2
In the [Image Effect] group, select the target
background bus to set.
Background A: Background A bus
Background B: Background B bus
3
In the [DME Select] group, select a DME channel
(DME 1 to DME 4) to assign.
You can check the DME channel status using the
button display.
On: DME channel assigned to the selected
background bus
Off: DME channel not assigned
Lock icon: DME channel assigned to a different key/
bus
To select a DME channel assigned to a different
key or bus
Use the override function. You can release the DME
channel assignment for another key/bus and then select
the DME channel.
To enable the override function, set the [Override] button
to the on state.
The DME channel is assigned to the selected background
bus and the lock icon displayed on the DME channel
button disappears.
Executing the Image Effect
Function
The image effect function can be executed on the cross-
point control block of the target switcher bank.
The DME effect to use for the image effect function must
be configured for the DME channel beforehand.
This section describes the background A bus as an
example.
Note
The button used to execute the image effect function must
be assigned to the cross-point pad/function button section
of the cross-point control block beforehand.
For details about assigning buttons in the cross-point
pad, see "Setting a Cross-Point Pad" (page 410).
For details about assigning buttons in the function button
section, see "Assigning Control Panel Buttons"
(page 402).
1
Press the [IMAGE] button, turning it on.
Use the [IMAGE] button for the cross-point button
row assigned with the background A bus.
2
Select a signal on the background A bus.
The signal set by the DME effect is output.
246