Setting Key Drop - Sony MLS-X1 User Manual

Setting a border
1
Press the [BDR] button, turning it on green.
2
Set the following parameters.
The parameters will vary depending on the separate
edge settings.
For details about separate edges, see "Setting
separate edges" (page 129).
When separate edges are disabled
No. Parameter
1 WIDTH
4 DENSITY
When separate edges are enabled
No. Parameter
1 TOP
2 LEFT
3 RIGHT
4 BOTTOM
To adjust the color of the edge fill signal
When a color matte is selected for the signal to insert in
an edge, you can adjust color 1.
For details about selecting an edge fill signal, see
"Setting the edge type" (page 128).
Press the [MORE] button to display the page 2 parameters
and set color 1.
No. Parameter Adjustment
2-1 LUM Luminance
2-2 SAT Saturation
2-3 HUE Hue
2-4 DENSITY Density
Setting a drop border or shadow
1
Press the [DROP BDR] button or [SHDW] button,
turning it on green.
2
Set the following parameters.
No. Parameter
1 WIDTH
2 POSITION
4 DENSITY
Adjustment
Width
Density
Adjustment
Top edge width
Left edge width
Right edge width
Bottom edge width
Adjustment
Width
Position
Density
To adjust the color of the edge fill signal
When a color matte is selected for the signal to insert in
an edge, you can adjust color 1.
For details about selecting an edge fill signal, see
"Setting the edge type" (page 128).
Press the [MORE] button to display the page 2 parameters
and set color 1.
No. Parameter
2-1 LUM
2-2 SAT
2-3 HUE
2-4 DENSITY
Setting soft edges
Note
When chroma key shadow is enabled, soft edge is
disabled.
1
Press the [SOFT EDGE] button, turning it on green.
2
Set the following parameter.
No. Parameter
1 SOFT

Setting Key Drop

This section describes the M/E-1 key 1 menu as an
example.
Setting key drop on mode
You can set key drop on mode and select whether to move
the key fill/key source position downward by eight lines
or four lines.
Note
In the following situations, key drop on mode is
automatically enabled.
• When the edge type is border, outline, or emboss
• When fine key is enabled
• When soft edge is enabled
1
Open the Home > M/E-1 > Key1 > Edge > Edge Type
Select menu (11101.21).
2
Set the [Key Drop] button in the [Key Delay Mode]
group to the on state.
131
Adjustment
Luminance
Saturation
Hue
Density
Adjustment
Edge softness