Setting A Wipe Crop - Sony MLS-X1 User Manual

Setting a Wipe Crop

Note
When Brick is set, Wipe Crop cannot be enabled.
1
Open the Home > DME > Channel1 > Edge > Wipe
Crop menu (15101.22).
2
Set the [Wipe Crop] button to the on state.
3
Press the [Pattern Select] button.
A pattern selection window appears.
4
Set the button for the target wipe crop pattern to the
on state.
Note
The wipe crop patterns are the same as wipe pattern
numbers 1 to 24 and 304.
5
Press [OK].
To invert the wipe crop area (Invert)
You can swap the inner and outer areas of the wipe crop
pattern.
Set the [Invert] button to the on state.
To set the radius of wipe crop pattern corners
(Radius)
You can set the radius of the four corners when pattern
number 304 is selected.
Set the [Radius] button to the on state and set the
following parameter.
No. Parameter Adjustment
1 Radius Corner radius
To replicate a wipe crop pattern (Multi)
You can replicate a pattern horizontally, vertically, or
both up to 63 times.
For details about pattern layouts, see "Replicating a wipe
pattern (Multi)" (page 159).
Set the [Multi] button to the on state and set the following
parameters.
No. Parameter Adjustment
1 H Multi Number of repetitions of pattern
horizontally
2 V Multi Number of repetitions of pattern
vertically
3 Invert Type Pattern layout (1 to 4)
To set the wipe crop pattern position and size
(Position/Size)
Set the [Position/Size] button to the on state and set the
following parameters.
No. Parameter
1 H
2 V
3 Size
5 Pattern
To set the aspect ratio of a wipe crop pattern
(Aspect)
Set the [Aspect] button to the on state and set the
following parameter.
No. Parameter
1 Aspect
To rotate a wipe crop pattern (Rotation)
In the [Rotation] group, select a rotation type.
Angle: Incline a pattern at a fixed angle.
Speed: Rotate a pattern at a fixed speed.
When the [Angle] button is selected, set the following
parameter.
No. Parameter
1 Angle
When the [Speed] button is selected, set the following
parameter.
No. Parameter
1 Speed
To add modulation to a wipe crop pattern
(Modulation)
In the [Modulation] group, select a modulation type.
H: Modulate a pattern in the horizontal direction.
V: Modulate a pattern in the vertical direction.
Set the following parameters.
206
Adjustment
Horizontal position
Vertical position
Pattern size
Pattern number (1 to 24, 304)
Adjustment
Aspect ratio
• Negative values expand
vertically.
• Positive values expand
horizontally.
Adjustment
Inclination angle of pattern
• A value of –1.00 corresponds to
a rotation of one turn
counterclockwise.
• A value of +1.00 corresponds to
a rotation of one turn clockwise.
• A value of 0.00 corresponds to
no rotation.
Adjustment
Rotation speed of pattern
• A value of –100.00 corresponds
to 4 revolutions/second
counterclockwise rotation.
• A value of +100.00
corresponds to 4 revolutions/
second clockwise rotation.
• A value of 0.00 corresponds to
no rotation (stationary).