Video Modifier Effects; Setting Defocus; Setting Sepia - Sony MLS-X1 User Manual

No. Parameter Adjustment
1 Amplitude Amplitude of modulation
2 Frequency Frequency of modulation
3 Speed Speed of ripples
• Negative values create waves
• Positive values create waves in
To modify a wipe crop pattern edge (Edge)
1
In the [Edge] group, select a type of edge.
Border: Adds a border to a pattern.
Soft: Softens the edges of a pattern.
Soft Border: Softens a border applied to a pattern.
When the [Border] button is selected, set the
following parameter.
No. Parameter
1 Width
When the [Soft] button is selected, set the following
parameter.
No. Parameter
1 Soft
When the [Soft Border] button is selected, set the
following parameters.
No. Parameter
1 Width
2 Inner Soft
3 Outer Soft
2
In the [Border Fill] group, select a signal to insert in
the border.
Flat Color: Single color
Ext Video: External input (Ext In) signal
When the [Flat Color] button is selected, set the
following parameters.
No. Parameter
1 Luminance
2 Saturation
3 Hue
in the down and left directions.
the up and right directions.
Adjustment
Border width
Adjustment
Edge softness
Adjustment
Border width
Softness of inner edge of
border
Softness of outer edge of
border
Adjustment
Luminance
Saturation
Hue

Video Modifier Effects

This section describes the menu for DME channel 1 as an
example.

Setting Defocus

Note
To use the Defocus effect, the DME channel must be set
to enhanced function mode.
1
Open the Home > DME > Channel1 > Video Modify
> Defocus menu (15101.31).
2
Set the [Defocus] button to the on state and set the
following parameters.
No. Parameter
1 H
2 V
3 All
3
In the [Defocus Mode] group, select a signal to which
to apply the Defocus effect.
Video/Key: Video signal and key signal
Video: Video signal only
To remove the black level leakage that occurs at
the edges of the screen
Set the [Clean Defocus] button to the on state.

Setting Sepia

Note
Enabling Sepia disables Mono if it is set.
1
Open the Home > DME > Channel1 > Video Modify
> Color Modify menu (15101.32).
2
Set the [Sepia] button to the on state and set the
following parameters.
No. Parameter
1 Mix Y
207
Adjustment
Defocusing in horizontal
direction
Defocusing in vertical
direction
Simultaneous defocusing
adjustment in horizontal
direction and vertical direction
Adjustment
Luminance signal mix amount