Executing A Utility Function (Utility/Shotbox Control Block) - Sony MLS-X1 User Manual

Command
AUTO PVW
Preset PVW
M/E-x Preview
P/P Preview
M/E-x Sub Preview
P/P Sub Preview
M/E-x K-PVW1
M/E-x K-PVW2
P/P K-PVW1
P/P K-PVW2
b) c) d)
M/E-x Key1 to 8 Preview
b) c) d)
P/P Key1 to 8 Preview
a) Applies only to output signals assigned in the Home > Setup > System >
Output > Output Assign menu (19101.41).
b) Cannot be assigned to cross-point buttons in the cross-point control
block.
Status of buttons assigned with a utility command
Command Utility control block
On
GPI 1 to 50 Test Fire Flashes light purple
Macro Cancel only at the moment the
Macro All Cancel button is pressed
Pre Macro Lit orange while the
Post Macro button is pressed
Macro Take Lit purple during macro
Macro All Take pause
(Gray characters
displayed on black
when the button is
disabled)
FTB Lit light purple, then lit
red when execution
ends
Other commands Lit orange
Executing a Utility Function (Utility/
Shotbox Control Block)
You can perform utility function operations using the
memory recall section in the utility/shotbox control
block.
Press a memory recall button assigned with an action to
execute the utility function.
Note
When using two utility/shotbox control blocks, the action
assignments are common to both.
Function
Auto preview
Preset preview
M/E-x preview
x = 1 to 5
P/P preview
M/E-x preview on the sub side in multi program 2 mode
x = 1 to 5
P/P preview on the sub side in multi program 2 mode
M/E-x key preview 1/key preview 2
x = 1 to 5
P/P key preview 1/key preview 2
M/E-x key 1 to key 8, key preview
x = 1 to 5
P/P key 1 to key 8, key preview
Off
Lit purple
Lit dark blue
Lit light purple during
macro execution
Lit purple
Lit dark blue
233
c) Linked to the key preview 1 setting in the Home > Setup > Switcher >
Config > K-PVW Config menu (19103.14).
d) The target key menu (last recalled menu) is displayed when a button
assigned with a utility command is double-pressed.
Cross-point control block
On
Flashes amber only at
the moment the button
is pressed
Lit amber while the
button is pressed
Lit amber during macro
pause
Lit amber, then lit red
when execution ends
Lit amber
Selecting a bank
A group comprising the 24 buttons of the memory recall
section are called a "bank."
There are 20 banks (1 to 20), and you select the target
button for operation by switching the bank.
Press a [BANK1] to [BANK20] button to switch the
memory recall section to function recall mode for the
selected bank.
Note
By default, bank 1 to 6 selection buttons are assigned.
To use bank 7 to 20, the bank 7 to 20 selection buttons
must be assigned to assignable buttons beforehand.
Off
Not lit
Not lit
Not lit during macro
execution
Not lit
Not lit