Control Of Routers; Destination Input List Display; Selecting A Level; Switching The Destination Input - Sony MLS-X1 User Manual

Setting an action when rewind is executed
On a GPI timeline, normally when the [REWIND] button
is pressed, an action set for the first keyframe is not
executed. When the [RUN] button is pressed, then the
first keyframe action is executed.
To execute a specific action when the [REWIND] button
is pressed, set a rewind action.
Note
The rewind action is enabled when you press the
[REWIND] button, even if you have configured an action
for the first keyframe to be executed after rewinding.
For details, see "Setting the operation of the first
keyframe when rewind is executed" (page 421).
1
Open the Home > External Device > GPI > Timeline
> Rewind Action menu (16103.12).
Rewind action settings information is displayed for
each GPI timeline port (1 to 8).
2
Select the target GPI timeline port for operation.
3
Set the [GPI Action] switch to the on state.
To disable an action, set the [GPI Action] switch to
the off state.
4
Press the [GPI Port] button and enter a GPI output
port number in the numeric keypad window.
Note
Set the trigger type for a GPI output port set as a GPI
timeline port to [Rising Edge], [Falling Edge], or
[Any Edge].
For details, see "Setting a GPI Output" (page 427).
To disable all action settings
Press the [All Off] button.
To test a trigger output
Press the [Test Fire] button.

Control of Routers

Destination Input List Display

You can check destination inputs in the Home > External
Device > Router > Router Xpt menu (16104.11).
The assigned destination and source are displayed for
each destination selection delegation button (1 to 64).
Destinations that have Inhibit enabled are grayed out.
A lock icon is displayed for sources that have protection
enabled on the MKS-R3210/R1620 Remote Control
Panel.
Notes
• Delegation button numbers 65 to 128 are not displayed.
• The destination assignment and inhibit settings are
configured in the Home > Setup > Panel > Router >
Delegation Button Assign menu (19104.51).
For details, see "Assigning a Destination" (page 415).

Selecting a Level

You can select the level used by the router.
For details about assigning the levels of level selection
buttons, see "Setting Levels" (page 416).
1
Open the Home > External Device > Router > Router
Xpt menu (16104.11).
2
In the [Level Button No./Level Assign] group, select
a level selection button to use.
Select one of the [Level 1] to [Level 4] radio buttons.

Switching the Destination Input

You can switch the source for a destination.
For details about creating a source table, see "Assigning
a Source Table" (page 415).
Note
Input switching is supported only for the destinations on
delegation button numbers 1 to 64.
1
Open the Home > External Device > Router > Router
Xpt menu (16104.11).
2
Select the target destination selection delegation
button to set.
229