Executing An Effect Timeline (Menu); Executing An Effect Timeline (Transition Control Block) - Sony MLS-X1 User Manual

Setting a loop
Press the [EFF LOOP] button, turning it on.
When an effect timeline is executed, it repeats executing
in an infinite loop.
To stop the loop, press the [EFF LOOP] button, turning it
off. You can also stop by pressing the [REWIND] button.

Executing an Effect Timeline (Menu)

Executing an effect timeline
1
Display the [Effect Timeline Recall/Store] taskbar.
The effect timeline switches to recall/store mode.
2
Select a region and recall an effect timeline register.
For details, see "Recalling an Effect Timeline"
(page 262).
3
Press the [Run] button.
The effect timeline is executed.
Note
You can set the operation when the [Run] button is
pressed again during effect timeline execution.
For details, see "Setting the operation when the
[RUN] button is pressed during effect timeline
execution" (page 421).
Moving to the start point/stop point
1
Display the [Effect Timeline Recall/Store] taskbar.
The effect timeline switches to recall/store mode.
2
Select a region and recall an effect timeline register.
For details, see "Recalling an Effect Timeline"
(page 262).
3
Press the [Rewind] button.
When executing in the normal direction, this moves
to the start point timecode.
When executing in the reverse direction, this moves
to the stop point timecode.
Note
If the start point is set lower than 01:00:00:00,
pressing the [REWIND] button moves to
01:00:00:00.
Setting the execution direction
1
Display the [Effect Timeline Recall/Store] taskbar.
The effect timeline switches to recall/store mode.
2
Select a region and recall an effect timeline register.
For details, see "Recalling an Effect Timeline"
(page 262).
3
Press the [Run Control] button.
The [Run Control] window appears.
4
In the [Direction] group, select an execution
direction.
Normal: Execute in the normal direction (from the
first keyframe to the last keyframe).
Normal/Reverse: Execution direction changes each
time the effect timeline execution finishes.
Reverse: Execute in the reverse direction (from the
last keyframe to the first keyframe).
5
Press [OK].
Setting a loop
1
Display the [Effect Timeline Recall/Store] taskbar.
The effect timeline switches to recall/store mode.
2
Select a region and recall an effect timeline register.
For details, see "Recalling an Effect Timeline"
(page 262).
3
Press the [Run Control] button.
The [Run Control] window appears.
4
Set the [Effect Loop] button to the on state.
When an effect timeline is executed, it repeats
executing in an infinite loop.
To stop the loop, press the [Effect Loop] button,
setting it to the off state. You can also stop by
pressing the [Rewind] button.
5
Press [OK].
Executing an Effect Timeline
(Transition Control Block)
You can operate a recalled effect timeline using the fader
lever in the transition control block/transition control
block (simple type) on the ICP-X7000.
273