Setting The Startup Mode; Applying Initial Status File Settings - Sony MLS-X1 User Manual

Setting the Startup Mode

You can set the startup mode for each of the switcher,
frame memory/clip player/SL key, and control panel.
Note
DMEs are included in the startup mode of the switcher.
However, DMEs do not support resume mode. When the
switcher is set to resume mode, DMEs start in custom
mode.
1
Open the Home > Setup > System > Start Up menu
(19101.11).
2
Select the target to set.
Select a switcher, frame memory/clip player/SL key,
or control panel.
3
Press the [Start Up Mode] button and select a startup
mode from the pull-down list.
Resume: Resume mode
Custom: Custom mode
When [Resume] mode is selected, steps 4 and 5 are
not required.
Note
You can set the frame memory/clip player/SL key
startup mode only when the switcher is set to resume
mode.
When the switcher is set to custom mode, frame
memory/clip player/SL keys are also set to custom
mode (fixed).
4
Press the [Setup] button and select a startup mode
from the pull-down list.
User: User setup
Factory: Factory default setup
Note
The setup mode cannot be set for frame memory/clip
player/SL keys.
5
Press the [Initial Status] button and select an initial
status mode from the pull-down list.
User: User setup
Factory: Factory default setup
Note
When the switcher is set to [Factory] in custom mode,
the initial status mode for frame memory/clip player/
SL keys is also set to [Factory] (fixed).
Saving user setup
User configured setup data and initial status data are
saved in non-volatile memory.
For details about saved data, see "Data Saved by [Setup
Define] and [Initial Status Define]" (page 528).
To save setup data
1
Open the Home > Setup > System > Start Up menu
(19101.11).
2
In the [Setup Define] group, select the target to save.
Switcher: Switcher
Panel: Control panel
3
Check the message, then press [OK].
To save initial status data
1
Open the Home > Setup > System > Start Up menu
(19101.11).
2
In the [Initial Status Define] group, select the target to
save.
Switcher/Content: Switcher and frame memory/clip
player/SL key
Panel: Control panel
3
Check the message, then press [OK].

Applying Initial Status File Settings

You can recall an initial status file to apply the setup
status saved in the file, regardless of the startup mode
settings.
Notes
• When the [Load and Recall Initial Status] switch is
enabled and an initial status file is saved, the setup
status at that point in time is saved.
For details about initial status files, see "Chapter 19
File Management" (page 329).
• Control panel and DME cannot be set.
• You can set frame memory/clip player/SL key only
when the switcher setting is enabled. When the switcher
setting is disabled, frame memory/clip player/SL keys
are set to off (fixed).
1
Open the Home > Setup > System > Start Up menu
(19101.11).
2
Select the target to set.
Select switcher or frame memory/clip player/SL key.
360