Configuring Snmp; Enabling/Disabling Snmp; Updating The Mib Product Id; Configuring Snmp V1 And Snmp V2C - Sony MLS-X1 User Manual

2
Press the [Install License] button.
A computer file selection dialog appears.
3
Select a license key file to install.
4
Check the message, then press [OK].
When installation is completed, a "The license was
successfully installed." message appears.
Uninstalling all licenses
1
Open the MLS Manager Home > License > Manage
Licenses menu (62101.01).
2
Press the [Uninstall All Licenses] button.
3
Check the message, then press [OK].
When uninstallation is completed, an "All of the
licenses were successfully uninstalled." message
appears.
Note
Licenses cannot be uninstalled individually.
Exporting unique device ID information
A unique device ID may be required when issuing a
license.
You can export and save a device information file that
contains the unique device ID to a computer or external
media connected to a computer.
1
Open the MLS Manager Home > License > Manage
Licenses menu (62101.01).
2
Press the [Export UDID] button.
A computer folder selection dialog appears.
3
Select a folder and save the device information file.

Configuring SNMP

You can configure SNMP settings.
You can provide information about the boxes and control
panels in an island to an SNMP manager via the SNMP
agent of MLS Manager.

Enabling/Disabling SNMP

1
Open the MLS Manager Home > SNMP > Common
menu (64101.01).
2
Enable/disable SNMP using the [Enable] button for
[SNMP Mode].
On: Enable SNMP.
Off: Disable SNMP.
When disabled, proceed to step 4.
3
Set whether to send a trap when authentication fails
using the [Auth Trap] button.
On: Send trap when SNMP authentication fails.
Off: Do not send trap when SNMP authentication
fails.
4
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button, check the message, then
press [OK].
5
Check the message, then press [OK].

Updating the MIB Product ID

1
Open the MLS Manager Home > SNMP > Common
menu (64101.01).
2
Press the [Refresh Product ID] button.
3
Check the message, then press [OK].
Configuring SNMP v1 and SNMP
v2c
You can configure a community and host when SNMP is
enabled.
484