Nonlinear Effects; Setting A Nonlinear Effect; Setting A Page Turn; Setting A Roll - Sony MLS-X1 User Manual

Nonlinear Effects

It is not possible to apply two or more nonlinear effects at
the same time. Enabling an effect automatically disables
the previously enabled effect.
This section describes the menu for DME channel 1 as an
example.

Setting a Nonlinear Effect

Select a type of nonlinear effect to enable.
1
Open the Home > DME > Channel1 > Non Linear >
Effect List menu (15101.51).
2
Press the button for the nonlinear effect to enable.
The setup menu for the selected nonlinear effect
appears and nonlinear effects become enabled.
To disable nonlinear effects
Press the [Off] button.

Setting a Page Turn

In the Home > DME > Channel1 > Non Linear > Effect
List menu (15101.51), press the [Page Turn] button to
display the Home > DME > Channel1 > Non Linear >
Page Turn menu (15101.52).
In the Home > DME > Channel1 > Non Linear > Page
Turn menu (15101.52), set the [Page Turn] button to the
on state and set the following parameters.
No. Parameter Adjustment
1 Radius Radius of the turned page flap
2 Offset Amount of page turn
3 Angle Angle of page turn
To split an image
In the [Split Mode] group, select a type of split.
H&V: Split horizontally and vertically (top, bottom, left,
right)
H: Split horizontally (left, right)
V: Split vertically (top, bottom)
To select a signal to insert on the back side of
the page
In the [Back Video] group, select a signal.
Self: Same signal as the front side
Flat: Single color
Hue Rotation: Gradually varying hue
2nd Channel: 2nd channel signal
When the [Flat] button is selected, set the following
parameters.
No. Parameter
1 Luminance
2 Saturation
3 Hue
When the [Hue Rotation] button is selected, set the
following parameters.
No. Parameter
1 Luminance
2 Saturation
3 Speed
Note
To set a 2nd channel signal, a DME channel for the
second channel must be selected beforehand.
For details about selecting a DME channel, see "DME
Effects for Keys" (page 134).

Setting a Roll

In the Home > DME > Channel1 > Non Linear > Effect
List menu (15101.51), press the [Roll] button to display
the Home > DME > Channel1 > Non Linear > Roll menu
(15101.53).
In the Home > DME > Channel1 > Non Linear > Roll
menu (15101.53), set the [Roll] button to the on state and
set the following parameters.
No. Parameter
1 Radius
2 Offset
3 Angle
To split an image
In the [Split Mode] group, select a type of split.
H&V: Split horizontally and vertically (top, bottom, left,
right)
H: Split horizontally (left, right)
V: Split vertically (top, bottom)
To select a signal to insert on the back side of
the roll
In the [Back Video] group, select a signal.
Self: Same signal as the front side
Flat: Single color
Hue Rotation: Gradually varying hue
2nd Channel: 2nd channel signal
When the [Flat] button is selected, set the following
parameters.
210
Adjustment
Luminance
Saturation
Hue
Adjustment
Luminance
Saturation
Speed at which the hue changes
Adjustment
Radius of the rolled portion
Amount of roll
Angle of roll