Key Edges; Setting Key Edges (Menu) - Sony MLS-X1 User Manual

2
Select content to unload.
To select and unload multiple content, place a check
mark beside the target content to unload.
To select and unload all content, place a check mark
in the Select All checkbox.
3
Press the [Unload from Memory] button.
To unload currently recalled content
Place a check mark in [Forcibly unload recalled
contents].
4
Check the message, then press [OK].
Recalling key fill/key source content
You can recall content for selection as a key fill/key
source for SL keys.
1
Open the Home > M/E-1 > Key5 > SL Key > Recall
menu (11105.63).
Content can be displayed in list view or thumbnail
view.
2
Select content to recall.
The content is recalled and selected as a key fill/key
source.
The key fill thumbnail, key source thumbnail, and
content name are shown on the left. "No Thumbnail"
is displayed if there are no thumbnails.
To lock the recall state of content
Set the [Lock] switch to the on state.
The content recalled on an SL key is locked and the
key fill/key source selection is fixed.
When locked, content recalled on an SL key cannot
be unloaded.

Key Edges

When edge type is selected, you can add modifiers, such
as a border, to the key.

Setting Key Edges (Menu)

This section describes the M/E-1 key 1 menu as an
example.
Setting the edge type
1
Open the Home > M/E-1 > Key1 > Edge > Edge Type
Select menu (11101.21).
2
In the [Edge] group, select an edge type.
Normal: Normal
Border: Border
Drop Border: Drop border
Shadow: Shadow
Outline: Outline
Emboss: Emboss
When the [Border] button or [Outline] button is
selected, set the following parameters.
No. Parameter
1 Width
3 Density
When the [Drop Border] button, [Shadow] button, or
[Emboss] button is selected, set the following
parameters.
No. Parameter
1 Width
2 Position
3 Density
When the [Normal] button is selected, the subsequent
setup is not required.
Note
The [Density] parameter for an emboss and the
[Density] parameter for the key can be adjusted
separately. When the [Density] parameter for the key
is set to 0.00, the key edge has the density set for the
emboss.
For details about the [Density] parameter for a key,
see "Setting the key type" (page 118).
128
Adjustment
Width
Density
Adjustment
Width
Position
Density