Installing; Mounting The Main Unit; Connecting Keypads - Bentel Security KYO 320 Installation Manual

Mounting the Main Unit

Please read this section carefully to get an overall view of
the steps involved in installing the KYO320 Main Unit. The
KYO320 Main Unit should be located in a safe, dry place
that is far from sources of interference.
Once you have selected a suitable place, create a lay -
out of all the system peripherals (Keypads, Readers,
Detectors, etc.) and ensure that you will be able to con -
nect the Main power, peripherals, and if necessary, the
telephone line to the KYO320 without difficulty. Allow at
least 5 cm of free space around the Main Unit for air
flow.
!
The Main Unit must be at least 2 metres from
GSM and radio relay systems.
Work carefully through the following steps (see Figure
on page 10).
1. Remove the screws 1 and frontplate.
2. Install add-on modules and boards (K3/VOX2,
etc.), refer to the respective paragraphs for instruc -
tions.
3. Drill the holes for the cabinet and Seize microswitch
bracket anchor screws (5 and 13 respectively).
4. Pull the connection wires through the wire entry 11
then attach the cabinet and Seize microswitch
bracket to the wall.
+
DO NOT over tighten the screws as this may dam-
age the Seize microswitch bracket.
5. Complete the connections — DO NOT connect the
MAINS until all other wiring has been completed.
6. Connect the Mains Power (refer to "Connecting the
Mains Power").
7. Program the
"PROGRAMMING"
"PROGRAMMING FROM KEYPAD" Guide for in-
structions).
KYO320
system (refer to
section and
n Connecting Keypads
Keypads should be located in places where full control
of the system is required: MIA-D, ALISON-DVP,
Alison-S(B029) and Alison/32LP Keypads can be sur -
face mounted on Mod. 503, 10x10 single gang and dou -
ble gang outlet boxes or similar.
+
Keypads should be mounted at eye level for easy
viewing.
Work carefully through the following steps (see Figures
on page 12) and/or respective manuals.
1. Remove the screws 66 and frontplate.
If you are installing a MIA-D Keypad go to step 3.
If you are installing an ALISON-DVPKeypad go to step 2.
2. Disconnect the Loudspeaker 82a from its Input
74a.
3. Push the PCB clip 78 upwards to release the PCB.
4. If you are surface mounting the Keypad: drill the
holes for the backplate anchor screws 76, and if re-
quired, for the Seize microswitch bracket screw 82.
5. If you are fitting a Seize microswitch (Order Code:
ASNC), push it firmly into its location (79 in Fig. 7)
and ensure that the Seize microswitch lever is held
firmly in position by the bracket tooth.
6. Pull the wires through the wire entry 70.
7. Using the anchor screws, secure the backplate and
Seize microswitch bracket to the wall.
+
Seize microswitches cannot be fitted to outlet
mounted Keypads.
8. Replace the PCB, and if required, connect the Seize
microswitch to the connector 65.
If you are installing a MIA-D Keypad go to step 10.
If you are installing an ALISON-DVPKeypad go to step 9.
the
the 9. Connect the Loudspeaker 82a to its Input 74a.
10. Assign the Keypad Address, then set the BPI Level
and complete the connections on the terminal
board (refer to "Connecting BPI Peripherals" for in -
structions).
11. Reattach the frontplate.

INSTALLING

INSTALLING
15