Chapter 3
Provisioning ports and connections
This section provides instructions on how to provision ports and connections
using the CLI. You can view the following topics in this section:
•
•
•
•
Modifying port settings
The portconfig command sets the line type, line coding, and signal mode for
DS-1/E1 ports on the service boards. See "Changing port configuration
settings" (page 33) and "Viewing port configuration settings" (page 33) for
information on the portconfig command. The syntax of the command is:
where
<port#>
[lineType=<value>]
[lineCoding=<value>]
[SignalMode=<value>]
"Modifying port settings" (page 31)
"Creating connections" (page 35)
"Viewing connections mapped to ports" (page 45)
"Deleting connections" (page 49)
portconfig [<port#> [lineType=<value>]
[lineCoding=<value>] [SignalMode=<value>]]
is the port number
is the line type for the port
Passport 8250 Command Line Interface Guide R2.2
is the line coding for the port
is the signal mode for the E1 port
31