Changing The Hardware Configurations; Opening The Contivity 4600 - Nortel Contivity 4600 Installing

Hide thumbs Also See for Contivity 4600:

Table of Contents

Chapter 4

Changing the Hardware Configurations

This section describes how to install or replace hardware components for the

Contivity 4600.

To replace power supplies, replace hard disk drives, or access the diskette drive

for system recovery operations, you must remove the switch's front bezel.

The first few times you remove the front bezel it might seem to resist removal.

This is simply because the ball stud and sockets are new. After a few times,

removal is easier. Remove the switch front bezel as follows:

Warning: Only Nortel Networks trained service personnel should

change existing hardware configurations. Improper handling of internal

components or assemblies, with the power connected, could cause severe

injury.

Caution: Wear an antistatic band when handling electronic components

for the switch to avoid damaging them.

Warning: Turn off the switch and unplug both power cords before

installing LAN and WAN cards or system memory.

Note: Removing the front bezel on the Contivity 4600 activates the

chassis intrusion alarm on power only. This intrusion is reported to the

system log file.

Installing the Contivity 4600

Table of Contents