How To Connect The System Cables - Sun Microsystems Enterprise 250 Owner's Manual

How to Connect the System Cables

Before You Begin
Complete these tasks:
"How to Power Off the System" on page 26
"How to Remove the Side Access Panel" on page 31
"How to Avoid Electrostatic Discharge" on page 35
"How to Remove the Fan Tray Assembly" on page 124
What to Do
1. Identify the cable you wish to install or replace. Use the information in the
following tables and illustrations to determine where to connect each end
of the cable.
Each cable connector is keyed so that it can be connected in only one way.
2. Install the cable according to the routing and cable management instructions
provided in the table.
Note – Part numbers listed in this section are correct as of the manual publication
date but are subject to change without notice. Consult your authorized Sun sales
representative or service provider to confirm a part number prior to ordering a
replacement part.
Chapter 8 Removing and Installing Backplanes and Cables 165