Sun Microsystems Enterprise 250 Owner's Manual page 139

4. Insert and tighten the four flat-head Phillips screws that secure the drive in
its bay.
5. Connect the removable media power cable to the power connector at the rear of
the diskette drive.
The connector is keyed and only fits one way.
6. Connect the diskette data cable to the data connector at the rear of the drive.
The connector is keyed and only fits one way.
What Next
Complete these tasks to reassemble the system:
"How to Install the Removable Media Assembly (RMA)" on page 104
"How to Install the Side Access Panel" on page 33
When you are ready to restart the system, be sure to run POST and OpenBoot
Diagnostic tests to verify that the system functions correctly with the new parts you
have just installed. You must also perform a reconfiguration boot so that your
system is able to recognize the new device(s). For additional information, see:
"How to Initiate a Reconfiguration Boot" on page 29
Chapter 6 Removing and Installing Storage Devices 121