Sun Microsystems Enterprise 250 Owner's Manual page 161

5. From the underside of the chassis, use a large flat-blade screwdriver to tighten the
two captive screws that secure the disk cage to the bottom of the chassis.
6. Stand the whole chassis upright.
Enlist the help of another person to accomplish this safely.
7. Finish tightening the two captive screws at the top of the disk cage.
8. Grasp the corner of the LED ribbon cable (hanging in front of the disk bay
opening), and fold the cable under itself, so that the label at the end is facing up.
9. Feed the end back into the disk bay opening and route it on top of the disk cage
toward the upper-left corner of the UltraSCSI backplane.
Arrange the middle portion of the cable so that it lies flat across the top of the disk
cage at the front of the chassis.
Chapter 7 Removing and Installing Miscellaneous Assemblies 143