Sun Microsystems Enterprise 250 Owner's Manual page 137

2. Remove the four Phillips screws securing the drive to the removable media
assembly.
There are two screws located on each side of the drive.
3. Slide the drive out the front of its bay in the removable media assembly.
Push the drive from the rear to start the removal process.
4. Place the drive on an antistatic mat.
5. If you are not replacing the drive right away, install a metal filler panel in the
empty drive bay.
Align the two metal retainer clips in the front of the drive bay, and press the filler
panel into place.
6. If necessary, install a plastic filler panel in the drive bay opening in the RMA
plastic cover.
Insert the two retainer posts into their corresponding slots and press on the filler
panel until it snaps into place.
What Next
To replace the diskette drive, complete this task:
"How to Install the Diskette Drive" on page 120
Chapter 6 Removing and Installing Storage Devices 119