Sun Microsystems Enterprise 250 Owner's Manual page 157
Hide thumbs
Also See for Enterprise 250:
- Owner's manual (369 pages) ,
- Rack mounting manual (178 pages) ,
- Conversion manual (92 pages)
Table of Contents
Advertisement
What to Do
1. Disconnect the LED ribbon cable from connector J0602 at the front of the
UltraSCSI backplane.
This connector is located in the upper-left corner of the backplane (as viewed from
the front). Lift the thin collar at the top of the connector to disconnect the cable.
2. Disconnect any remaining cables from the rear of the UltraSCSI backplane:
a. Disconnect the UltraSCSI power cable from connector J0101.
b. Disconnect the UltraSCSI data cable from connector J0102.
c. Disconnect the keyswitch/LED cable from connector J0103.
d. Disconnect the keyswitch cable from connector J0601.
Chapter 7
Removing and Installing Miscellaneous Assemblies
139
Advertisement
Table of Contents
Troubleshooting
