Sun Microsystems Enterprise 250 Owner's Manual page 197

2. Plug in the TPE cable to the appropriate RJ-45 connector.
You should hear the connector tab snap into place.
3. Plug in the other end of the cable to the TPE outlet in the wall or the floor.
You should hear the connector tab snap into place.
See your network administrator if you need more information about how to connect
to your network.
Note – You can use only one of the main logic board Ethernet ports. You cannot
connect to the main logic board's TPE and MII ports at the same time. For
information about connecting to the MII port, see "How to Attach an MII Ethernet
Transceiver" on page 180.
What Next
If you are installing your system, complete the installation procedure. Return to:
"How to Install the Enterprise 250 Server" on page 13
If you are adding additional interfaces to the system, then you need to configure
those interfaces; see:
"How to Add an Ethernet Interface" on page 175
Chapter 9 Administration and Networking 179