Sun Microsystems Enterprise 250 Owner's Manual page 121

6. Slide the removable media assembly out of the system chassis.
Be sure that you feed all the cables carefully out of the RMA chassis opening as you
remove the assembly.
Note – At this point all the power and data cables are attached to the rear of the
drives installed in the assembly.
7. Place the assembly on an antistatic mat.
What Next
For information about removing drives from, or installing drives in the removable
media assembly, see:
"How to Remove the Diskette Drive" on page 118
"How to Install the Diskette Drive" on page 120
"How to Remove a CD-ROM Drive or Tape Drive" on page 113
"How to Install a CD-ROM Drive or Tape Drive" on page 115
To replace the removable media assembly, complete this task:
"How to Install the Removable Media Assembly (RMA)" on page 104
Chapter 6 Removing and Installing Storage Devices 103