Sun Microsystems Enterprise 250 Owner's Manual page 257

4. To start the SunVTS software, enter:
# cd /opt/SUNWvts/bin
# ./sunvts -display local_hostname:0
Substitute the name of the workstation you are using for local_hostname. Note that
/opt/SUNWvts/bin is the default /bin directory for SunVTS software. If you've
installed SunVTS software in a different directory, use the appropriate path instead.
When you start SunVTS software, the SunVTS kernel probes the test system devices.
The results of this probe are displayed on the Test Selection panel. For each
hardware device on your system, there is an associated SunVTS test.
5. Fine-tune your testing session by selecting only the tests you want to run.
Click to select and deselect tests. (A check mark in the box indicates the item is
selected.)
To select or deselect all the tests in the Memory group
Memory...
kmem(vmem)
To select or deselect individual memory tests
Results
If SunVTS tests indicate an impaired or defective part, see the replacement
procedures in Chapter 5 through Chapter 8 to replace the defective part.
mem(pmem)
Chapter 11 Diagnostics and Troubleshooting 239