Sun Microsystems Enterprise 250 Owner's Manual page 102

4. Engage the notch in each lever with its side of the CPU card cage.
5. Simultaneously push both levers toward the center of the CPU module until it is
fully seated in its connector.
What Next
Complete the following task to reassemble the system:
"How to Install the Side Access Panel" on page 33
When you are ready to restart the system, be sure to run POST and OpenBoot
Diagnostic tests to verify that the system functions correctly with the new parts you
have just installed. You must also perform a reconfiguration boot so that your
system is able to recognize the new device(s). For additional information, see:
"How to Initiate a Reconfiguration Boot" on page 29
84 Sun Enterprise 250 Server Owner's Guide • June 1998