Sun Microsystems Enterprise 250 Owner's Manual page 46

2. Turn on power to the monitor or terminal.
A terminal or monitor is required for viewing system messages. For setup
instructions, see "How to Attach an Alphanumeric Terminal" on page 20 or "How to
Configure a Local Graphics Console" on page 22.
3. Turn the front panel keyswitch to the Power-on ( ), Diagnostics (
Locked (
See "About the Status and Control Panel" on page 8 for information about each
keyswitch setting.
Note – The system may take anywhere from 30 seconds to two minutes before video
is displayed on the system monitor or the ok prompt appears on an attached
terminal. This time depends on the level of power-on self-test (POST) diagnostics
being performed.
28 Sun Enterprise 250 Server Owner's Guide • June 1998
) position.
), or
Keyswitch